D3 24-bit DAC/Headphone Amp — Audioengine Skip to Content
Tech Specs

W3R Add-on Receiver for W3 (Open Box)

Technical Specifications

General specifications

DAC type
USB

Input
USB audio

D/A converter
AKM4396

USB transfer mode
Asynchronous dual clock

USB controller
TI1020B

USB device class
Type 1.1 or above

Input bit depth
16 bit, 24 bit (upsampled to 24 bit)

Input sample rate
48.1kHz-96kHz native playback
188.2kHz & 192kHz re-sampled to 96kHz

Output
Analog 3.5mm mini-jack stereo

Full-scale output level
2.0V RMS

Output impedance
2 ohms

Recommended headphone impedance range
12 ohms to 10K ohms

Headphone amplifier
LME49726

Frequency response
10Hz-25KHz (+/- 0.5dB)

SNR
(DC to 20kHz) >110dB

THD+N
(1kHz FS 96kS/s) <0.002%

Crosstalk
-110dB

Power requirement
USB 5V DC, 200mA

USB power filtering
2-stage redundant regulation

Product dimensions
1.9×0.6×0.375" (48x15x10mm)

Shipping weight
1.0lbs (0.5kg)

Environmental
Operating Temperature: 32 to 95 degrees F
Non-operating Temp: -4 to 113 degrees F
Relative Humidity: 5% to 95% non-condensing

Included accessories
1/8″ to 1/4” adapter cable
Setup guide
Product case

D3 Internal Converter
The heart of the D3 is the AK4396 DAC, which is well-regarded for its low noise and high fidelity. Due to the high signal-to-noise specs of the AK4396 and the added benefit of double redundancy power source conversion and filtering, the D3 presents impressive low noise and low distortion characteristics. The D3 can process digital audio at any bit depth up to 24 bits and any sample rate up to 192kHz. D3 pads (upsamples) all bit depths internally to 24-bits, thus achieving a higher signal-to-noise ratio.

D3 Headphone Amplifier
The D3 contains a high-performance headphone amplifier based on the LME49726 low-noise opamp. This amp is able to provide low-impedance, high-fidelity audio and a 2-volt output which easily drives a wide range of headphones, satisfying even the most demanding headphone enthusiasts. The D3’s relay-controlled stereo output can also be connected to any system with an analog audio input, such as Audioengine powered speakers.

D3 Power
The D3 is powered directly from the USB bus and power is passed through two stages of regulation to ensure no USB bus power variations affect the audio quality. This low-noise, low-ripple power supply is located on a separate circuit board for extra isolation and thermal management.

D3 Volume Control
Volume is controlled from the computer’s OS and is implemented in the D3 as a digitally-controlled analog volume control.